How To Repair Pin In Bobbin Winding Shaft

Follow the steps beneath is you are experiencing this outcome

one. Press downwardly on the spool pin lever with your finger. The spool pin will swing up.

2. Remove the spool pin cap.

3. Fully insert the spool of thread for the bobbin the spool pin. Slide the spool onto the pivot and so that the spool is horizontal and the thread unwinds to the front at the bottom.

iv. Slide the spool cap onto the spool pin. With the slightly rounded side of the spool cap positioned toward the left, slide the spool cap onto the spool pin every bit far equally possible to the right so that the spool is moved to the right stop of the spool pin.

When sewing with fine, cross-wound thread, utilize the minor spool cap, and go out a pocket-size space between the cap and the spool.

v. While property the spool with your right hand, and so pass the thread nether the thread guide.

6. Pass the thread under the thread guide cover from the back to the front. Hold the thread with your right manus and then that there is no slack in the thread that is pulled out, and so laissez passer the thread nether the thread guide cover with your left mitt.

Brand sure that the thread passes nether the pre-tension disk.

Make certain that the thread is pulled as far as possible into the pre-tension deejay; otherwise the bobbin may not be wound tight and fifty-fifty.

7. Pull t he thread to the right, pass information technology under the hook of the bobbin-winding thread guide, and and then air current the thread counterclockwise betwixt the discs, pulling information technology in as far every bit possible.

8. Put the bobbin onto the bobbin winder shaft and slide the bobbin winder shaft to the right. Turn the bobbin clockwise, by paw, until the spring on the shaft slides into the notch in the bobbin. Brand sure to pull out 7 to 10 cm (ii-iii/four to three-15/16 inches) of thread from the hole on the bobbin.

9. Plow the sewing machine on.

x. While holding the end of the thread, gently press the human foot controller or press the Outset/Terminate button to wind the thread around the bobbin a few times. And so end the automobile.

If the sewing machine is to be operated using the foot controller, connect the pes controller before turning the machine on.

     - When the pes controller is plugged in, the starting time/stop push cannot be used to beginning sewing.

11. Trim the excess thread in a higher place the bobbin. Pull 1 cm (3/8 inch) of thread from the hole on the bobbin.

12. Slide the sewing speed controller to the right (to set the speed to fast). (For models equipped with the sewing speed controller.)

13. Press the foot controller or press the Outset/End button to outset the machine.

fourteen. When the bobbin seems full and begins spinning slowly, have your foot off the foot controller.

15. Cut the thread, slide the bobbin winder shaft to the left and remove the bobbin.

How To Repair Pin In Bobbin Winding Shaft,

Source: https://help.brother-usa.com/app/answers/detail/a_id/74396/~/bobbin-thread-is-loose

Posted by: wightwitte1972.blogspot.com

Share this post